Vacuum Bagging Supplies

A complete starter vacuum bagging kit for room temperature repairs and small laminating projects up to 13 sq ft. Some item specifications may vary....

Resinflow 60 is designed to assist resin flow through your part during the VARTM (Vacuum Assisted Resin Transfer Moulding) process. This material i...

Polyethylene Tubing is used to connect the vacuum reservoir to the part to be infused. Available with a 1/2" O.D. and a 3/8" I.D. for use with 3/8"...

AirTech Spiral Wrap air duct infusion hose is used to allow air, and eventually excess resin, to be pulled from the perimeter of a molded product. ...

Used to connect polyethylene tubing and/or spiral wrap together, to make your network of vacuum infusion lines to the laminate. "Barbed" ends enabl...

Used to connect polyethylene tubing and/or spiral wrap together, to make your network of vacuum infusion lines to the laminate. "Barbed" ends enabl...

Used to connect polyethylene tubing and/or spiral wrap together, to make your network of vacuum infusion lines to the laminate. "Barbed" ends enabl...

Greenflow 75 is designed to efficiently distribute resin with little waste due to the low profile, tight construction. Greenflow 75 can be used wit...

Enkachannel for resin infusionEnka-Channel is a 50 mm wide, 4 mm thick, supply or feeder channel for VARTM, consisting of a black three-dimensional...

Enka-Channel is a 100 mm wide, 4 mm thick, supply or feeder channel for VARTM, consisting of a black three-dimensional polyester filament core stru...

Nylon film, resistant to polyesters, epoxies and vinylester with excellent elongation and strength for contours. .0015 x 60" x 1000 ft. 10% off...

Stretchlon 200 is green in color with a 250° F maximum temperature usage. Stretchlon 200 is ideal because it is able to stretch to compress every a...

NuTack-E Reactive Epoxy Based Spray Adhesive 22.5oz Your formula for stronger bonds While conventional spray adhesives work for adhering dry good...

A "venturi" type of a valve that allows you to generate a vacuum from a positive pressure air line. Less expensive than a vacuum pump.

A multi-purpose tape with a pressure sensitive adhesive for easy clean up, to hold down vacuum bagging materials. 1" x 72 yards (2.54cm x 66m)

inexpensive polyethylene parts, used to connect the vacuum manifold and resin feed lines for low temperature resin infusion projects. RIC 12 is use...

A negative pressure gauge that allows you to see how much vacuum pressure is actually on your laminate and if your vacuum bag is sealed or leaking....

This perforated release film provides excellent release from polyesters, vinylesters, and epoxies. 285°F (140°C) The small hole perforations allow ...

Lightweight breather that allows you to pull "full" vacuum and remove volatiles without vacuum trap off that can warp laminates. 60" x 100 yards   ...

This release film provides excellent release from polyesters, vinylesters, and epoxies. 285°F (140°C) Good elongation and conformability. .001" x 6...

Vacuum Reservoir RB 451 is designed to collect excess resin during the infusion process and prevent damage to your vacuum pump. 2.5 gallon tank siz...

Designed to provide accurate, controlled vacuum that you can see and adjust. 1/4" NPT fittings

Safelease® 30 is a non-silicone waterbased PTFE release liquid. It will release any laminate from any type of mold surface and will withstand tempe...

A "through the vacuum bag" connector that allows you to easily pull vacuum. Work jointly with our AQD 500 quick disconnect. 1/4" NPT Thread Fitting...