Airtech International

Greenflow 75 is designed to efficiently distribute resin with little waste due to the low profile, tight construction. Greenflow 75 can be used wit...

Nylon film, resistant to polyesters, epoxies and vinylester with excellent elongation and strength for contours. .0015 x 60" x 1000 ft. 10% off...

Stretchlon 200 is green in color with a 250° F maximum temperature usage. Stretchlon 200 is ideal because it is able to stretch to compress every a...

NuTack-E Reactive Epoxy Based Spray Adhesive 22.5oz Your formula for stronger bonds While conventional spray adhesives work for adhering dry good...

A "venturi" type of a valve that allows you to generate a vacuum from a positive pressure air line. Less expensive than a vacuum pump.

A multi-purpose tape with a pressure sensitive adhesive for easy clean up, to hold down vacuum bagging materials. 1" x 72 yards (2.54cm x 66m)

A negative pressure gauge that allows you to see how much vacuum pressure is actually on your laminate and if your vacuum bag is sealed or leaking....

inexpensive polyethylene parts, used to connect the vacuum manifold and resin feed lines for low temperature resin infusion projects. RIC 12 is use...

Lightweight breather that allows you to pull "full" vacuum and remove volatiles without vacuum trap off that can warp laminates. 60" x 100 yards ...

This perforated release film provides excellent release from polyesters, vinylesters, and epoxies. 285°F (140°C) The small hole perforations allow ...

This release film provides excellent release from polyesters, vinylesters, and epoxies. 285°F (140°C) Good elongation and conformability. .001" x 6...

Safelease® 30 is a non-silicone waterbased PTFE release liquid. It will release any laminate from any type of mold surface and will withstand tempe...

Vacuum Reservoir RB 451 is designed to collect excess resin during the infusion process and prevent damage to your vacuum pump. 2.5 gallon tank siz...

Designed to provide accurate, controlled vacuum that you can see and adjust. 1/4" NPT fittings

A "through the vacuum bag" connector that allows you to easily pull vacuum. Work jointly with our AQD 500 quick disconnect. 1/4" NPT Thread Fitting...

Nylon film, resistant to polyesters, epoxies and vinylester with excellent elongation and strength for contours. .0015 x 60/120" c fold x 500 ft. ...

High tack sealant tape that is wider and thicker than our AT-199. Excellent clean up. Roll size is 1/8" x 1/2" x 25 ft. (3.2mm x 12.7mm x 7.62m)

A tight weave all white polyester peel ply to texture the laminate surface, avoiding sanding or abraiding as a surface prep for painting or bonding...

Econostitch® is a non-coated nylon peel ply fabric with red tracers which make this peel ply more visible before and after cure, reducing the possi...

Econotac 2 is an economical rubber based contact spray adhesive, designed for temporary bonding applications.Econotac 2 can be used to hold dry f...

Econolease is a silicone treated nylon peel ply which provides greater release in difficult environments.Our Econo peel plies are designed to work ...

A heavier version of our Econo Ply J, used when extra strength is needed for removal. An excellent texture to the laminate surface is acheived, avo...

1/4" NPT Thread Fittings (female)

Airtac 2 MEGA is a spray rubber adhesive designed for temporary bonds. Airtac 2 MEGA can be used on materials needing extra tack for placement on v...