Placeholder ARK East System Pump Instructions - Noah's Marine Skip to content

Country

RESOURCES

ARK East System Pump Instructions

ARK EAST SYSTEM PUMP INSTRUCTIONS

ASSEMBLY

Push the extension tube firmly into the bottom of the large BLUE DOT pump, this is the 1032 resin pump.  Hold the pump against the side of the resin container so the cap is level with the container cap. Mark and cut the extension tube at an angle about 3/8” from the bottom. Insert pump in the container. Repeat with the small RED DOT (HARDENER) pump.  

USING THE PUMPS

Depress pumps several times until you get a steady stream.  Discard this mixture.  Use only full pump strokes, an improper mix, either too much or too little will result in an improper cure.  When dispensing more than one shot at a time repeat one resin, and one hardener instead of trying to keep track of the number of shots of resin and hardener.  Mix thoroughly scraping the sides and bottom of the container before using.

ONE stroke on each pump will produce .8oz/24 ml mixed epoxy

At low temperatures, viscosity increases and could cause pump breakage by having to press too hard or produce an incorrect ratio.  Keep the Epoxy at room temperature until you are going to use it.

STORAGE

Leave the pumps mounted on the containers for storage, cleaning with solvent could damage the pump seals resulting in an incorrect mix.  After long-term storage, do a sample batch or measure with graduated containers to check the ratio before using it on a project. Store at room temperature, keep upright on the disposable foil as there may be a few drips.  Do not freeze.

Click here to download these instructions for offline use