Mr. Sticky's Cold Bond
"Cold-Bond allows application in temperatures from 20° - 60° Farenheit.!"
Mr. Sticky's® Cold-Bond Uses
Most people want to know what is different about this adhesive versus existing glues:
Bonding in Low Temperatures: Creating successful bonds below 55°Farenheit is not possible with most adhesives. Cold-Bond allows application in temperatures from 20° - 60° Farenheit.
Procedure:
a. Dispense and mix the adhesive for at least 2 minutes at room temperature (70°F) or above per the instructions on the syringe label.
b. Clean the materials to be bonded by cleaning with solvents (non oily solvents such as MEK, Acetone or Denatured Alcohol).
c. Roughen parts to be bonded with 80 grit sandpaper.
d. Clean the materials to be bonded again by cleaning with solvents (non oily solvents such as MEK, Acetone or Denatured Alcohol).
e. Using the adhesive that was mixed at room temperature, apply it to the cold parts to be bonded and assemble the parts. You may have to act quickly, as the adhesive will become very viscous (thick) when it is cooled. One can bond a cold part to a warm one.
f. Allow Adhesive to cure. The initial cure can take 48-96 hours.
g. If cured at 20° F for 96 hours, Cold-Bond tested to a shear strength of 650 Psi when applied to Cold Rolled Steel in our laboratory.
h. If cured at 36° F for 48 hours, Cold-Bond tested to a shear strength of 1,100 Psi when applied to Cold Rolled Steel in our laboratory.
In addition to bonding at low temperatures, this adhesive offers the following advantages over many traditional epoxies:
Toughened: Resilient grip to substrate, bends instead of breaking, resists shock and vibration.
Memory: Post-deflection adhesive returns to original shape.
Exterior Waterproof Cold-Bond is Waterproof and Exterior rated. It can also be applied to wet or dry substrates. Note: many adhesives are “water resistant' not “waterproof”, cannot be applied or maintain bonds in wet or exterior environments.
Non-Sag formula Cold-Bond is made “to stay where you put it”. This highly thixotropic (non-sag) formula resists sagging during application and curing. A 1/4” diameter bead of glue, applied horizontally on a vertical surface, will not run, but will cure in place. This means that it will also stay in place when applied to your project.
APPLICATIONS: Pipes, Gutters, Concrete, Wood, Metal, Plastic, Ceramic. Tank Repair including gray water, irrigation, septic, boat, RV, farm. Irrigation line, sprinkler lines, parts on Boats, Jet Skis, Kayaks, Wind-Surf-Boards, Motorcycles, Canoes, Spas, Pool Equipment, Furniture, Tractors, Trucks, Drains.